I Love Wool: A Lanolizing Tutorial

Amy blogs over at Anktangle and I’m so excited to be sharing her AMAZING lanolizing tutorial with you. Connect with her on Facebook and Twitter for many wonderful natural parenting stories, tutorials, and valuable information!

My son began to get painful, infected diaper rashes right before his first birthday. After a bit of trial and error (and a couple visits to our pediatrician), we figured out that he had developed a sensitivity to the synthetic cloth diapers that we were using for him. Because of that, we switched completely to natural fiber fitted diapers and prefolds.

Little lambs know: wool is the best!

Since these kinds of natural fiber lack a built-in waterproof outer (like the pocket diapers we were using) I used our trusty PUL covers. It didn’t take long to notice that even in a cotton diaper on with a PUL cover, Daniel would still sometimes get rashy. So I decided to make the plunge into the wonderful world of wool, and I’ve never looked back!

I crocheted my first wool soaker for him and I was hooked. (Please forgive the pun.) I knew about the magical properties of wool, but I’d been too intimidated by the washing routine to make the switch. Turns out, my fears were totally unfounded: washing wool is incredibly easy. And since it actually gets cleaner when it gets wet (as lanolin converts to a type of antibacterial soap when it comes in contact with wetness) wool only needs to be washed if it gets soiled. I end up washing my wool covers very infrequently, and I’ve never noticed them smelling bad. In fact, the wool covers get soiled so infrequently, that I usually feel the need to lanolize before I need to wash them.

Lanolin is a waxy substance secreted by the sebaceous glands of sheep which protects their coats and makes their wool waterproof, thereby aiding in the shedding of water when sheep are standing in the rain. Lanolin in wool diaper covers acts the same way: providing a water resistant coating to the outside of the wool fibers, which allows it to both repel (from the outside) and absorb (on the inside) liquid. Over time, the lanolin in a diaper cover will get used up, and you may notice some contact wetness or small leakage when your baby pees. When that begins to happen, it’s time to replenish the supply of lanolin present in the diaper cover.

The process is simple and easy! I’ve made a short video tutorial to show you how to do it. (Read to the bottom for written instructions.)

How to Lanolize

Do this step after washing a soiled soaker in gentle soap or wool wash and rinsing it thoroughly, or without washing first to increase waterproofing.

Supplies:

  • 100% pure lanolin (a pea-sized amount for one diaper cover)
  • A few drops of gentle liquid soap (like a wool-specific wash or a liquid castille soap like Dr. Bronner’s)
  • A sink or other basin for soaking your wool in the lanolin
  • Wool item(s) to lanolize (wool nursing pads, wool diaper cover/soaker, etc.)

The Steps:

  1. Fill your clean sink (or wherever you do your hand washing) with room-temperature (or slightly cool) water. Take care not to make the water too warm or too cold, as you don’t want to stress the fibers of the wool.
  2. Put a pea-sized dollop of lanolin in your palm.
  3. Add a couple of drops of the liquid soap and mix it together with your finger until the two are well incorporated. (You’ll be able to feel when the soap and lanolin have combined, as the texture will be consistent throughout.)
  4. Rub your hands together and swish them in the water to disperse the lanolin throughout.
  5. Put the wool soaker in the lanolin bath, being sure to get it fully submerged. (I like to move it around in the water a bit and I’m always sure to open it up to get a lot of contact between the inside of the cover and the lanolin water.
  6. Allow it to soak there for 10 minutes or so.
  7. Gently squeeze (don’t wring!) the soaker to remove some of the excess water.
  8. Place it on a small towel or prefold and roll it up, gently squeezing to remove even more excess water.
  9. (Reshape and) lay it flat to dry on a dry towel or drying rack.

That’s it! Your wool soaker is now just as waterproof as it was the day you got it, and you won’t have to lanolize it again for a while.

These days, we do a lot of elimination communication (EC) and time spent at home in a cotton diaper without a cover. But for naps and nighttime, when we go out or when one of us is done with EC for the day, I always reach for my wool covers first. They’re incredibly effective protection against wetness while still being breathable; they’re both soft and adorable. Perhaps most importantly, they’re made of a natural, renewable, biodegradable fiber that I know is completely safe to for my son to wear next to his most sensitive parts.

I love wool!

Thanks so much for sharing, Amy! I can’t tell you all how many times I’ve needed help with something and the only fix is watching a video to really SEE what’s going on.

Photobucket
… Oh so many ways to follow along …
BlogGFCBlog Lovin’FacebookTwitterPinterestVote
(Visited 399 times, 1 visits today)

You May Also Like:

Comments

  1. says

    I'm glad you liked the tutorial, Gretchen! I had fun making it. =)

  2. hobomama says

    This is so cool! It's funny how everyone lanolizes differently — I'm glad to see your method. It looks nice and simple.

  3. Jen Kirk says

    Hi, what wool did you use? Will any merino work?

    • Gretchen says

      Any wool will do as long as it is 100% wool.